Metal Finishing Power

Service for Over 25 Years
   
0 ITEM(S) IN YOUR BAG / TOTAL:$0.00
Category
  Rectifiers - Green Series 
  Meters & Feeders 
  Probes 
  Pumps & Spare Parts 
    Single Pumps  
    Dual Pump  
    Hoses  
    Pump Parts  
  Rectifier Parts 
  E-coat Systems 
  Downloads 
  Reward Points 

 

 
Home > E-coat Systems
Anode Monitor System
Reward Points
3833 points will be rewarded to you when you buy this item.
Anode Monitor System
Item Id: 295-1-ANMN
Review this item Review this item
Your Price:
$3,833.33
Availability:
Back Order
Choose Options
ANODES
Quantity
Email a friend Email a friend
Add to Wish List Add to Wish List
Description
The Anode Monitor System is designed to measure and report on electric current flowing through each Membrane Electrode Cell in your E-coat paint tank. This information can be viewed near the E-coat tank on the remote control panel.  More powerfully, it can be delivered to your PC via RS-232 protocol or via an optional Ethernet adapter. 

By measuring all Cells remotely in a fraction of a second, the Anode Monitor is especially useful when it is impractical to use a clamp-on ammeter, or in paint tanks where it is not efficient to measure one Cell at a time. 

Features
  • Standard units are available in the following sizes: 20, 30, 40, 50, 60, 70, & 80 position. Other sizes are available upon request.
  • Built in multiples of 10. For example, a tank with 34 Cells would use the 40 position system, allowing for future increased capacity.
  • 12.7 mm (1/2”) thick copper bus bar with 2 x 12.7 mm (1/2”) holes for line connections.
  • Each Cell is protected with a fuse. 
  • NEMA 4x fiberglass enclosure box.
  • DC Shunts are integrated into the panel.  All load wires begin at the panel, reducing possible discrepancies among individual Cell current readings. 
  • Remote Panel can display 2 lines of text or 1 Cell at a time.
  • Includes free software for PC (2000/XP) to display the results via RS232/RS485 connection.
Properties
  • Standard design’s maximum amp draw per Cell is 50 amps.
  • 120 VAC 1 phase (1 Amp) power is required.
  • Can perform a measurement every 500 ms (2 times a second).
  • Output signals are protected by a high voltage isolation scheme.
Options
  • Local DC Shunts placed near ME Cells.
  • MODBUS TCP – Ethernet.
  • MODBUS RTU – Serial.
Mailing List Subscribe to our Newsletter
Subscribe
Unsubscribe
JP Tech, Inc. 2286A Church Street PO Box 863 East Troy, WI. 53120 US 262.642.7671
Copyright JP Tech, Inc.. All Rights Reserved. Shopping Cart Software powered by 3DCart.